Description

Overview

The NF-T27/T29 pressing block is an OEM pressing block for chainsaw assemblies. It is listed for T27 and T29 firewood processors. Therefore, use it when you service the chainsaw assembly on those machines.

Compare the block with the part you remove before you fit it. Also, check the mating surfaces for wear. Then, fit the new block and recheck the assembly.

Also, use clean tools and a clean work area during assembly. Dirt on the mating surfaces can cause a poor fit. Therefore, wipe the parts before you tighten anything.

Also, record which block you fitted and the date. This makes the next service faster, because you know what was installed and when.

Pressing block for chainsaw assembly work

For example, you can match the block to the chainsaw assembly during a rebuild. Then, confirm the position matches the old part. Finally, check the assembly before you run the processor.

Key features

• OEM pressing block for chainsaw assemblies
• Listed for T27 and T29 firewood processors
• Sold as an individual part

Also, keep the block with the chainsaw assembly parts you already use. Therefore, the service job stays simple.

Specifications

Confirm these figures before you order.

• Part type: OEM pressing block
• Use: chainsaw assembly
• Machines: T27 and T29 firewood processors

Compatibility

This block is listed for T27 and T29 firewood processors. Therefore, confirm your model before you order.

Confirm that the block matches the chainsaw assembly, the processor model, and the page listing before you install it.

If your model is different from the T27 and T29 listing, confirm the match with the page details before you order.

Fit check for the block

First, read the model on your processor. Next, compare the block with the old part. Then, check the chainsaw assembly before you install. For the full processor, see our NorthForest T29FHC firewood processor page. To learn more about the saw unit, read the Wikipedia article on chainsaws.