Description

Overview

The NF-T29 chain is a 22 inch saw chain with 3/8 inch pitch and .063 inch gauge. The product page lists the processor compatibility as T27FHC in its table. Therefore, check the processor model with your dealer before you order the NF-T29 chain.

This page gives you the facts from the product listing. It also explains how to use and care for the chain. Read the specifications and the compatibility notes before you order.

How to use the saw chain

Before you start, check that the chain tension and the bar fit are correct. Then run the saw at low speed for a short test. Next, keep the chain sharp and lubricated while you cut. Stop the saw if the chain binds or runs hot.

Also, check the chain after each long job. For example, look for worn cutters, loose drive links and cracked links. If you find damage, replace the chain before you continue.

Care for the saw chain

Keep the chain clean and oiled between jobs. Sharpen the cutters at regular intervals. Store the chain dry and away from dirt. For related parts and attachments, visit our accessories page. To read about saw chains in general, see the Wikipedia article on saw chains.

Key features

• 22 inch chain length
• 3/8 inch pitch
• .063 inch gauge (1.6 mm)
• Industrial specific mounting type (D009 type)

Also, these features help you match the chain to your bar. For example, the pitch and the gauge must match the bar and the sprocket. So, check both values before you order.

Specifications

The product page lists only the items below. No other values are added.

Caractéristique	Détails
Marque	North Forest
Modèle de Barre	T27FHC
Compatibilité	Processeur T27FHC
Longueur	22 pouces
Pas de chaîne (Pitch)	.375″ (3/8″)
Jauge	.063″ (1.6mm)
Type de montage	Industriel Spécifique (D009 Type)

• Stihl code: C-3621-77
• Oregon code: 75LPX077G

Compatibility

The product page lists the processor compatibility as T27FHC. The product photo is labeled as a T29FHC firewood processor chain. Therefore, confirm the processor model and the bar fit with your dealer before you order.

Before you buy, compare the 22 inch length and the 3/8 inch pitch with your bar. Then, confirm the .063 inch gauge with your saw. This step helps you avoid a wrong order.