Description

Overview

The NF-T27-cable is an auto-cycle remote cable for the North Forest T27. The product page lists it for T27 machines from 2019 to 2021. Therefore, use this page to check the model year and the cable ends before you order a cable for your processor.

How a remote cable works on a processor

A remote cable transfers a push or pull movement from a control to a moving part on the machine. When you operate the control, the cable moves the part in the same direction. To read about the general design of control cables, see the Wikipedia article on Bowden cables.

Before you start, switch off the processor and disconnect the power source. Next, note how the old cable runs and where each end connects. Then compare the new cable ends with the old cable, because the product page notes small changes to the cable end connections. Finally, operate the control slowly and check that the cable moves the part without binding.

Care for the cable

Keep the cable and its ends clean, and free of sawdust and bark. Check the sheath and the ends for kinks, cracks, or wear at regular intervals. For related parts and attachments, visit our accessories page.

Key features

• Auto-cycle remote cable for T27 machines
• Listed for T27 models from 2019 to 2021
• Small changes to the cable end connections

Also, these features help you match the cable to your machine. For example, the model years show which T27 builds the cable is listed for. So, check your model year before you order.

Specifications

The product page lists only the items below. No other values are added.

• Product name: NF-T27-cable
• Type: auto-cycle remote cable
• Machine: T27
• Model years: 2019 to 2021

Compatibility

The product page lists the T27 for 2019 to 2021. The page does not list the cable length or the end fitting type. Therefore, measure the old cable, and confirm the cable ends with your dealer before you order.